CarboAir Carbon Filters Markets Best Filters
Carbo Air Carbon Filters Has 3 Depth Beds 50mm, 60mm and 100mm Depth Beds Depending on how strong the odour depends on the Bed Depth. That in mind Rhino Pro and Mountain Air both Have 50mm Depths with Rhino Hobby 36mm Depth Making CarboAir the thickest and best grade Carbon on the Market.
its no myth that the environment is the key to a successful harvest when growing plants indoors. maintaining the perfect temperature Humidity and co2 is crucial. Carbo Air has a 55.5% more open Mesh than other market leading Brands this stops too much drag which can be caused by your filter stopping your extraction System to work at its full potential
- Kills grow room smells
- Hand Built to system Air Standards
- Works with any Fans
- Designed to be used with System Air Fans for ultimate efficient Air Flow
- Machine washable pre-filter sleeve included and pre-fitted
- Maintain high performance levels at the rated airflows for at least 18 months
Carbo Air 50 is the entry Level Yet it is the same thickness as other market leading filters like rhino and mountain Air
CarboAir 60s have a thicker Bed which means more airflow can be pulled through the filter still gurantee no smell Designed for the smelliest plants to give the grower 100% piece of mind
Designed for Large Grow Rooms with Large Odours, Some Growers Double Filter. with the 100mm Bed there is no need as theoretically it is already double filtering these filters will take Massive Air Flow Rates
Max Airflow Rates for CarboAir 50:
4″ 100mm/330mm CarboAir – 410m3/hr
5″ 125mm/330mm CarboAir – 480 m3/hr
6″ 150mm/330mm CarboAir – 600 m3/hr
8″ 200mm/500mm CarboAir – 1000 m3/hr
10″ 250mm/500mm CarboAir – 1200 m3/hr
12″ 315mm/500mm CarboAir – 1500 m3/hr
Using the Filter:
Carbon filters must be matched to the fan that they are being used with in terms of the diameter of the venting and the air flow rate. If the air-flow rate of the fan is too high for the filter then the air will flow through it too quickly to be cleaned properly.
Before use, the plastic wrap should be removed from around the outside of the drum CarboAir have already pre-fitted your pre-filter.
Your CarboAir filter needs to mounted inside or as close as possible to your grow-space and connected to your extractor fan by means of ducting and Duct Clips or by a fast clamp which joins the filter and the fan directly together. However they’re fitted together, it’s essential that all joins are airtight for the fan and filter system to work effectively. The outside of the filter should not be covered or obstructed as this will reduce filter’s efficiency. Smaller filters and fans are commonly fitted into grow-tents and grow-room by hanging them from hanging bars or ceiling fittings. In this way they do not reduce your amount of floor-space and they remove the warmest air which tends rise. Larger filters may be too large and cumbersome for hanging and can be simply sat on the floor. Once the filter and your fan have been located in your grow-space, ducting can be run from the outlet side of your extractor fan to outside of the grow-space.
CarboAir filters are designed to be fitted to the intake side of your extractor fan and should never be fitted to the outlet side. In other words air must be sucked through them and never blown out through them. Blowing air through them will make them ineffective and may even damage them internally. The dust-filter around the outside should be removed and washed when it gets dirty in order to maintain air flow.
Moisture degrades the performance of carbon filters. High humidity makes them ineffective at eliminating smells and reduces the expected life-span by a significant amount. Try to keep humidity at a reasonable level (between 40% and 60%) and both your carbon filter and your plants will benefit.