Lumii Digita Switchable Ballast – 400w/600w/1000w

Lumii Digita Switchable Ballast

This ballast can be operated between four different output settings, this allows you to either use 400w, 600w, 1000w HID lamp with the same ballast. You can also have a boost setting in 1000w lamps. It is built with great quality and cheap to buy! It even comes with safety features built into the onboard digital controller.

This product converts mains electricity and edits it to the correct voltage through a microprocessor which controls a digital power output system to start up and power a HID lamp. They are cost effective compared to coil and core magnetic ballasts. When using coil and core magnetic ballast over time they degrade, become noisy, and run less efficient. The Lumii Ballast does not do this.

This ballast can run a variety of different HID lamps allowing you the option to choose the best lamp for you. It can also run 400w, 600w, 1000w halide lamps (ensure they are only run at their rated output).

Benefits of using Lumii Digita Switchable Ballast:

•  Built with high quality materials and cheap to buy.
•  Runs three different HID lamps – 400w, 600w, 1000w.
•  New feature boost setting for 1000w.
•  Improves efficiency of your HID lamp.
•  Very quiet when operating.
•  Operates at a low temperature.
•  Compatible with metal halide and high pressure sodium. 
•  More efficient than core and coil magnetic ballasts.
•  Safety feature to detect abnormalities. 

Check out our other Lumiii products by clicking here!

How to use Lumii Digita Switchable Ballast:

*Note* this ballast should not be used to dim lamps below the intended output.

This product should be on a flat and firm surface. It must be positioned in a good ventilation area.

To set up, connect the input lead of your reflector to the output lead of the ballast (make sure the cable is not pulled tight or in contact with anything warm/hot).

Tightly screw the lamp into the bulb holder.

Position the reflector at the correct desired height.

Connect the mains plug into a electrical outlet socket and turn it on. This will trigger the ballast to start up and light the lamp. If there is any interruption to the mains supply do not restart this process until the lamp has cooled down.